Rx invalid nwid:0 invalid crypt:31 invalid misc:0 Link Quality:5 Signal level:217 Noise level:199 To test this, enter the iwconfig command. The drivers should be installed and work now. The Broadcom's wl driver conflicts with the kernel's b43 driver, so create the /etc/modprobe.d/nf file (name doesn't matter, but it's nice to have something intuitive) using the text editor of your choice as root and add the following lines to it :Īt this point, reboot your machine. If at any point you upgrade your kernel, you will have to do this process again, because the module is compiled against the running kernel only. Make sure to download the source code relevant to the architecture of your installation (32-bit or 64-bit). Navigate to the 's broadcom-sta page and build the package according to the instructions given. If a working internet connection is available on the laptop (say a wired connection), use sbopkg to install the drivers : Where username is the name of your user account. If the output does not contain netdev, then as root, enter the following command : The first thing is to check if the user is part of the netdev group : The regular user account on the laptop must also be a part of the netdev group. There should also be a way to transfer files to the target laptop - it can either be a working internet connection using the laptop's ethernet card, or a different machine with internet access and a USB thumb drive to transfer the files. This tutorial assumes a full Slackware installation. It deals with installing Boradcom's official proprietary wl driver for Linux that includes support for Broadcom's BCM4311-, BCM4312-, BCM4313-, BCM4321-, BCM4322-, BCM43224-, and BCM43225-, BCM43227- and BCM43228-based hardware. This tutorial is written for setting up wireless on Slackware on laptops with Broadcom wireless cards.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |